Bogie Hearth Furnace
Car bottom loading furnace is made from structure with full aluminium silicate fiber jilt silk rug module built furnace, furnace bottom use of lightweight insulation brick and heavy firebrick lining.
This type furnace is suitable for all kinds of mechanical parts heat treatment. such as: solid solution stainless steel, high manganese steel quenching, valves, flange, pressure vessel, ring rolling stick, steel pipe, steel wire, steel ball, casting, forging, cast iron, roll, blade, high speed steel, tool steel, automobile axle, diesel engine, gearbox, mining machinery, loader bridge arm all sorts of products and so on quenching and tempering, annealing, tempering, normalizing heat treatment .
1. Up to 1-2 ton capacity.
2. Uniformity of ± 5 Celsius.
3. Furnace shell made of thick stell plates, welded to structural units.
4. 30 segment prorgammable PID auto controls.
5. PC connecting Micro software is avaiable.
6. Loading on bogie hearth.
● PID automatic control via SCR (Silicon Controlled Rectifier) power control with phase angle fired, current limiting resistor.
± 5℃ over 100 mm @ 1200℃
K type (Ni-Cr to Ni-Si) with 99.7% purity Alumina tube
Spring wire or belt of Fe-Cr-Al Alloy doped by Mo
High quality insulation materials
Double layer steel casing with dual cooling fan, surface temperature below 60℃
● steel plate and steel oven door adopt manual or mechanical transmission
110V or 220V, 50HZ/60HZ, 1 phases (As per your order)
● One year limited warranty with lifetime support. (Consumable parts such as heating elements and crucibles are not covered by the warranty, please order the replacement at related products)
● Cooling rate shall also not exceed 10 ℃/min.